cylinder head的例句大全

The features of cylinder block and cylinder head core assembly vertical casting process are introduced.

介绍了缸体、缸盖组芯立浇工艺的特点.

互联网摘选

The conclusions are of benefit to the improvement of the diesel engine with integrated cylinder head.

得出的结论有益于对整体式气缸盖柴油机的改进设计.

互联网摘选

The cast production technology and its control means of Cumins 6 BT cylinder head production are described.

叙述了康明斯6BT气缸盖铸造生产工艺及控制手段.

互联网摘选

Place the engine cylinder head over the dowels.

将引擎汽缸头放在销上.

互联网摘选

This is achieved by using cylinder head gasket.

这通过使用气缸盖衬垫实现.

互联网摘选

Remove control cables from cylinder head cover clip.

从汽缸头盖扣夹上移去控制拉索.

互联网摘选

The basic casting method-design principle of cylinder head was introduced.

介绍灰铸铁缸盖铸造工艺的基本设计原则.

互联网摘选

Clean the exhaust manifold and cylinder head mating surfaces.

清洁排气歧管和汽缸头配合面.

互联网摘选

The most common cylinder head types are the hemi, wedge, and semi-hemi.

最常见的气缸盖类型是半球形, 楔形和准半球形.

互联网摘选

A process of cylinder-head structure optimum is described in this paper.

介绍了气缸盖的结构优化过程.

互联网摘选

A new lateral casting process was introduced to produce YC 6 M cylinder head.

介绍了生产YC6M缸盖的侧浇铸造新工艺.

互联网摘选

The cylinder head is attached to the block with high-tensile steel studs.

气缸盖与气缸体用高强度的钢螺栓缚连结.

互联网摘选

The cylinder head is heavily finned for strength.

汽缸头附有许多突片以增加强度.

《现代英汉综合大词典》

The powder cylinder head good case of impurities. 3.

夺目把粉缸关好,以防杂质出去.

互联网摘选

The main defect of type YC 4112 Q cylinder head is blowhole.

气孔为YC4112Q气缸盖的主要缺陷.

网络文摘精选

A thermal radiant sensor is designed to measure the radiant heat flux of the cylinder head.

设计并制作了测量缸内辐射热流量的热辐射传感器,测量了不同碳酸二甲酯添加比例下缸内辐射热流量.

互联网摘选

In the end, the control strategy of VVA was applied in a 4V cylinder head and experimental results proved its good adaptability.

最后，将可变气门控制策略应用于4V发动机缸盖，试验结果表明，可变气门控制策略具有良好的适应性。

互联网摘选

A bolt is fastened through the bush to thereby fix the rocker shaft on a cylinder head.

螺栓穿过衬套被紧固，从而将摇臂轴固定在气缸盖上。

互联网摘选

A theoretical analysis is made of the transmission characteristics of the cyclic surface temperature variations in the cylinder head.

从理论上分析了周期性温度波在缸盖内的传播特性。

互联网摘选

If parts of the crank drive were replaced, you must determine the new cylinder-head gasket again by measuring the piston projection in "tdc" position.

如果曲柄传动的零件已更换，则必须测量活塞在“tdc”位置的突出部分以重新确定新的气缸垫是否恰当。

provided by jukuu